![]() Easy to use interface with context menus, popup hints etc.Typically less than 5% CPU utilization on a 2.0GHz P4.Over-sampled oscillators and sample-accurate triggering.100% synthetic sound, rendered in real-time.Pattern based drum-machine engine, synced to the host. ![]() Eight channel drum and percussion synthesizer.The sound of MicroTonic is 100% synthetic and rendered in real-time.Sonic Charge MicroTonic doesn't use any samples or pre-rendered waveforms. You can use MicroTonic as a sound module to play drum sounds from your MIDI keyboard or sequencer, or you can use the built-in pattern engine to play drum patterns in sync with your sequencer. Sonic Charge MicroTonic is a VST / AU plug-in featuring a unique drum and percussion synthesizer combined with a pattern based drum-machine engine. The charge indicator light will blink 3 times quickly.Sonic Charge MicroTonic 2.0.1 Description: When the batteries are in need of charging Plug the power supply into the wall outlet and connect the magnetic plug to the We recommend fully charging every month when the unit is in storage. The unit should be charged 3-4 hours when the indicator light indicates that the unit needs to be charged.įully charge the unit before extended periods of no use. To maximize the capacity and life of the rechargeable batteries, give the unit a full charge (4 hours) prior to the first use. For Cordless Advanced and Cordless Select models: The battery will bleed down its charge in 6-9 months. Do not allow the product to completely discharge.įully charge the unit before extended periods of no use. For extended battery life, the battery should be charged at least 8-10 hours after 7-10 reservoirs of water. Do not use the unit with the charger pin engaged. To maximize the capacity and life of the rechargeable batteries, give the unit a full charge (24 hours) prior to the first use. Rinse by repeating with a full reservoir of clean warm water.With the unit in the OFF position, allow gravity to drain the vinegar solution through the Water Flosser.If your tip is removable, remove the tip, set pressure control dial to high, place the handle in the sink.(Consult the instruction manual for specific replacement information for each tip.)Īdd 2 tablespoons of white vinegar to a full reservoir of warm water. It is recommended that when applicable, you replace tips every 3-6 months.If this process fails to start the flow of water, insert a jet tip and gently draw on the tip as you would a drinking straw.Then point the handle downward towards the sink and turn the unit on this generally starts the flow of water within 30 seconds. Set the Water Flosser to the highest pressure setting, and if the handle has an on/off slide switch, make sure it is in the ON position.Confirm the unit is plugged into an active electrical outlet.Press down firmly to engage the reservoir to the base of the unit. Ensure the reservoir is firmly seated onto the base of the unit. Fill reservoir at least half-full of water.If your unit has a black rubber valve in the water reservoir, ensure that the black valve is installed with the dome side facing up and the four-pronged side facing down to connect with the base of the unit.
0 Comments
Leave a Reply. |